CorelockCorelocks diagonal design locks positioner 1-1/4" deep into core of CMU preventing movement of positioner during block installation. Rebar is automatically centered in core.
SureTieWIRE-BOND®'s SureTie® installs easily on steel stud/brick veneer applications. One-piece design provides superior strength. SureTie® has a #12-24 tapping thread 1" in length. Accommodates wallboard thicknesses of 1/2" and 5/8", and various sizes of insulation.
Level
Eye Adjustable System WIRE-BOND®'s Level Eye is a continuous adjustable system designed with in-plane eyelets welded to the side rod of 3/16" or 9 gauge wire. Profile of the entire welded assembly -- eyelets, pintles, cross and side wires -- does not exceed 3/16" in height. This insures complete mortar coverage for maximum strength.
Type
III-X AnchorWIRE-BOND®'s Type III-X Anchor installs quickly and easily on exterior walls with brick veneer while providing positive contact with metal studs. It transfers compression loads to the steel stud backup. Available in 14 gauge and 12 gauge (plate). 1 1/4" wide x 6" long. Finishes include mill galvanized, hot dip galvanized, and stainless steel.
Plumb-RiteThis new product keeps vertical joints in precise alignment where control joints and expansion joints are used in a masonry wall. No more tedious guesswork. Plumb-Rite is T-shaped and constructed of PVC. It is rigid enough to keep a 3/8" vertical joint consistently straight, and flexible enough to allow for expansion of the brick.
HCL-711
Anchoring SystemWIRE-BOND's HCL-711 Anchoring System installs quickly and easily on exterior walls with brick veneer while providing positive contact with metal stud and avoiding damage to wallboard.
Level
Adjustable Tab U.S. Pat.# 6,735,915
Available for both ladder and truss, Level Adjustable tab has in-line tabs welded to side rods of 9-gauge or 3/16" wire. Tab lengths extend beyond block to accommodate varying widths of insulation. Tabs and wall ties are 3/16" diameter wire.
Copper
Aqua-Flash®A composite flexible flashing composed of a layer of polyester film bonded to a solid sheet of soft tempered copper bonded to 32 mils of a highly adhesive SBS modified bitumen (rubberized asphalt) with a removable silicone coated liner.
NBL
Spacer The NBL spacer is used in conjunction with the welded ladder wire reinforcement. This reinforcement aligns itself with the cross rod intersections which are spaced at exactly 8” centers, allowing for clearance on the block cores to install rebar reinforcement.